Step 1: Turn on the power switch;
Step 2: Enter the touch screen automatic interface and open the software on the computer desktop, and wait 1-5 seconds for the computer to connect to the controller successfully;
Step 3: Check and confirm that there are MARK points on the printed materials for alignment;
Step 4: Switch the automatic interface to manual mode and enter the manipulator setting interface;
Step 5: Now you need to set the discharge position, turn the handwheel to Y, shake the handwheel, and set the near-point position of the discharge;
Step 6: Turn off the table top suction, click the discharge cylinder button, under the cylinder, click the discharge suction button to absorb the material, press the discharge cylinder button, a piece of material is sucked up, shake the handwheel to set the midpoint position;
Step 7: Shake the handwheel again to set the remote discharge position, press the discharge cylinder, close the discharge suction, and release the discharge cylinder;
Step 8: Click the button to adjust CCD, move the camera to find the MARK point (note that there should be no other similar points beside the field of view of the MRAK point to prevent accidental capture);
Step 9: At this time, you can set up the online version and set the printing parameters (if you need to fine-tune the platform when installing the online version, you can enter the platform debugging interface to move the platform);
Step 10: At this time, take the final sample and select the MARK point (as long as it has feature pairs, such as holes, characters, corners, etc.);
Step 11: Take a good sample, after moving the cross target, click the CCD calibration button, after calibration, be sure to switch the auto-on button to the auto-off button.
