There are some common questions for the CCD target hole drilling machine from our customers, hope these solutions are helpful.
Q1: If it don't drill on the center of the target.
A1: Click four arrows to adjust the deviation, to which direction is deviated, we should adjust it towards the opposite direction through these four arrows.
Q2: If the hole is not drilled.
A2: Enter "param", increase the driftdis, driftdis means the height of the drill when it drills, the max value can be set is about 19.
Q3: How to process the center calibration?
A3: Find a black substrate, put it into the drilling position, click "manwork", click "work", then it drills a hole, adjust the brightness, after that then click "return" . Click "study", adjust well the circle position and "save". Click "return"
Double click left-top corner, comes up a box, then click left button. It drills one hole, move material, then drills the second, third, fourth and fifth holes,after drilling five holes, click "save".
Double click left-top corner, comes up a box, then click left button, after drilling hole, click "save" to finish the calibration.
Q4: How to change the drills?
A4: Push Cover Plate button, the plate goes up, pull away the plate, then use size 12 and size 10 wrench, the size 10 stuck on the bottom of the drill and the size 12 stuck on the top, the twist and take out the drill and change it.