One: The automatic punching machine ensures that the input AC power is 220V~50HZ for water and electricity.
Second: ensure the input air source (subject to the parameters)
Three: Make sure that the mold male and female molds enter and match.
Ensure that the material being processed is within the pressure range (no plate punching for non-automatic target machines, such as high-hardness metal plates).
Five: Regularly release water for the air compressor. The air compressor output gas is not dried, and it is drained once a week.
Six: Check if the foot cup is stable and balanced. Is the foot cup nut tightened?
Seven: The automatic punching machine regularly checks whether the visible screws are loose.
Eight: Regularly check whether the plug of each electrical component is loose.
Automatic punching machine
Nine: Regularly wipe the countertop with a damp cloth to keep the countertop clean.
Ten: Equipment moves carefully Do not break the marble countertops.
Eleven: Check if the equipment grounding is normal.
Twelve: Clean the circuit control cabinet once a month
Thirteen: Grease the oiling holes of the automatic target machine once a month.
Fifteen: Stop the operation of the device and shut down according to the normal shutdown. Do not directly shut down the host, so as to avoid system data loss and other defects.
Sixteen: Keep the ground clean, especially on the linear guide of the sliding frame.
Seventeen: Every week, the unpainted part of the automatic target machine should be coated with anti-rust oil, and then wiped with a clean cloth to keep a layer of oil film on it to prevent the machine from rusting.
Eighteen: The electrician must check the travel switch once a week, and the proximity switch is tight.
Nineteen: When it rains, be sure to do the waterproof protection of the automatic punching machine.